1 System is over water supply
To control the water supply by adjusting
the valve or change to the water pump with lower power.
2 Non-evenness of the water spreading
on the paper pad
To check the installation
is under the correct way or not. Adjust valve to control
the water supply; Change the water pump with more
power or water pipe with high caliber. Clean the pool,
pump entrance, filter and pipe etc. in time. Eliminate
the dirt inside the water recycling system.
3 leaking treatment
To check whether water is
over supply, pad is damaged, dilapidated on the edge
or leaking at the connection. Use silicon glue to
plug after water supply stops.
4 Pad cleaning
Elimination of the scale and
alga on pad's surface: Use the soft brush to remove
up and down after the pad's completely drying out.
Do not remove horizontally. (Can brush a small part
to verify if the pad stand or not). Then only switch
on the water supply system to wash the scale and alga
on pad's surface. (Do not use steam or high pressure